COBHAM SAILOR Fleet One Installationshandbuch Seite 40
- Seite / 132
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 2: Installation
98-141368-A 32
To connect the data connection status kit (optional)
The optional SAILOR Fleet One data connection status kit (part number 403744A-981)
can be purchased from your distributor. It consists of:
•A switch for enabling/disabling data connection
• An indicator lamp for showing the status of the data connection
Wires: Additionally you must provide 2 wires for the switch and two wires for the indicator.
Specifications for the wires:
• Max. wire diameter: 0.8 mm
• Max wire cross-section for stranded cable: 0.75 mm
2
Pin connection: The switch and lamp connect to the I/O connector on the SAILOR Fleet One.
The next sections describe how to connect. For details on the I/O pins, see the previous
section.
To connect the data connection switch
The data connection switch is used to enable/disable data connection in the SAILOR Fleet One.
It is a latched push-button, which contains two switches: One that is normally open and one
that is normally closed.
The below procedure is an example with default configuration of I/O pins, and the button
is used to disable data connection when pushed in (latched).
1. If you want to disable data connection when the button is pushed in, solder your wires to
pin 1 and 2 on the switch.
2. Mount the switch in the location you want and tighten the nut (max. torque 50 Ncm).
3. Connect the other end of the wires to pin 4 and 6 respectively on the I/O connector.
When you push the button in, the SAILOR Fleet One gracefully deactivates any active data
connections and does not allow any new data connections to be started. Data connections are
not allowed until the button is released (pushed) again.
Note
A data connection is not necessarily started when you release the button - this
depends on whether or not automatic activation is enabled. See Set up the data
connection on page 67.
12
34
- SAILOR Fleet One 1
- Disclaimer 2
- Trademark acknowledgements: 2
- Safety summary 1 3
- 98-141368-A iv 4
- Related documents 5
- Typography 5
- Table of contents 6
- Chapter 5 Configuration 7
- Chapter 1 9
- Introduction 9
- Features and interfaces 10
- Main units 11
- Tools for setup and use 12
- Available services 12
- Satellite coverage 13
- Chapter 2 14
- Installation 14
- Obstructions 15
- Radiation hazard 16
- Interference 16
- Radar distance 17
- 98-141368-A 10 18
- Antenna mast design 19
- Antenna mast length 20
- Install the antenna 21
- Important mounting notes 22
- Mount the antenna 23
- Where to place the terminal 24
- Install the terminal 25
- 98-141368-A 18 26
- 98-141368-A 19 27
- 98-141368-A 20 28
- Connect cables 29
- DC power input 30
- 98-141368-A 23 31
- To connect to the ignition 32
- Phone interface 33
- LAN interface 34
- 98-141368-A 27 35
- 12345678 36
- I/O pin functions 37
- 98-141368-A 32 40
- 98-141368-A 33 41
- Power cable selection 42
- Power cable recommendations 43
- 98-141368-A 36 44
- Chapter 3 45
- Get started 45
- Power up the SAILOR Fleet One 46
- Connect a smartphone 47
- 98-141368-A 40 48
- Connect an IP handset 49
- Connect an analogue phone 50
- Connect a computer 50
- Make a call 51
- Connect to the Internet 52
- Chapter 4 53
- Operation 53
- Call log 54
- To make local phone calls 55
- Dialling functions 56
- Data connection 57
- Physical connection options 58
- To access the Internet 58
- The built-in web interface 59
- Overview of the web interface 60
- To navigate the web interface 61
- Dashboard 62
- 98-141368-A 55 63
- 98-141368-A 56 64
- Phone book 65
- To edit the phone book 66
- SMS messages 68
- 98-141368-A 61 69
- To configure message settings 70
- Do you need a SIM PIN? 71
- To enter the SIM PIN 71
- 98-141368-A 64 72
- Wrong PIN 73
- Chapter 5 74
- Configuration 74
- Set up the data connection 75
- Set up the interfaces 76
- 98-141368-A 69 77
- 98-141368-A 70 78
- 98-141368-A 71 79
- 98-141368-A 72 80
- Select a preferred satellite 81
- Log on as administrator 82
- 98-141368-A 75 83
- 98-141368-A 76 84
- Save or load a configuration 85
- Call charges 86
- Log handling 87
- Data limits 87
- Configure the SIM PIN 88
- To change the PIN 89
- Set up user permissions 90
- Restricted dialling 91
- 98-141368-A 84 92
- External data connections 93
- 98-141368-A 86 94
- Track the SAILOR Fleet One 95
- 98-141368-A 88 96
- Antenna RF noise filter 97
- Chapter 6 98
- Update software 99
- 98-141368-A 92 100
- Part numbers 101
- Troubleshooting guide 102
- 98-141368-A 95 103
- Status signalling 104
- Generate a diagnostic report 105
- Event messages 106
- 98-141368-A 99 107
- 98-141368-A 100 108
- 98-141368-A 101 109
- 98-141368-A 102 110
- 98-141368-A 103 111
- 98-141368-A 104 112
- Extended status 113
- Antenna properties 113
- Self test 114
- Reset button 115
- 98-141368-A 108 116
- List of reserved subnets 117
- Appendix A 118
- Technical specifications 118
- Environmental specifications 119
- 98-141368-A 112 120
- Dimensions are in mm 121
- SAILOR Fleet One terminal 122
- 98-141368-A 115 123
- 98-141368-A 116 124
- Weight: 2.2 kg 125
- Glossary 126
- 98-141368-A 119 127
- 98-141368-A 120 128
- 98-141368-A 121 129
- 98-141368-A 122 130
- 98-141368-A 123 131
- 98-141368-A 124 132
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.170 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern