
Chapter 2: Installation
98-141368-A 20
To install the terminal on a bulkhead
Terminal with no cable support
Do as follows to mount the terminal on a bulkhead:
1. Insert four screws through the mounting holes and into the mounting surface.
2. Connect all cables.
Terminal with Basic cable support
First mount the Basic cable support on the terminal as described in Mount the Basic cable
support (optional) on page 19.
1. Mount the terminal with the Basic cable support on the bulkhead by inserting four screws
through the holes in the mounting bracket and into the mounting surface.
2. Connect all cables.
3. Secure the cables to the cable support using cable strips.
To install the terminal on a desktop
Four rubber feet make the terminal well suited for desktop installation. Simply place the
terminal on a desktop and connect all cables.
If required, fasten the terminal to the desktop with four screws, as described in the previous
section To install the terminal on a bulkhead.
Make sure that the grounding requirements are met. See Ground the terminal on page 17.
This mounting method cannot be used for grounding. If you are using the
mounting surface for grounding, you must use the threaded bushings on the
underneath of the terminal instead. See Ground connection through the
mounting surface on page 18.
Kommentare zu diesen Handbüchern