COBHAM C406-2 SERIES Spezifikationen PDF herunterladen (Seite 15)

Artex Aircraft Supplies, Inc. 570-0049 Revision -

Page 15 of 30

Table 4: ELT Interface 453-0041 Front View

Example:

The following information highlights the wiring of the ME406 ELT series to the ELT interface 453-

0041:

ME406 SERIES ELT 453-0041 ELT INTERFACE

DESCRIPTION

PIN OUT PIN OUT

Light 2 6

Reset 1 6 3

Reset 2 13 4

External ON 14 8

Ground 7 7 and 9

Horn power 8 5

Horn ground 7 or aircraft ground 7

5.1.4 The wires for the interface 453-0041 are crimped and inserted inside the D-sub connector 150-

0022 using the same procedure highlighted in the “Cable Harness” section.

NOTE: Do not close the backshell if the two communication wires have not been installed yet.

Refer to section “453-0032 wiring to 453-0041” in this document to complete the wiring

across the interfaces.

5.1.5 Install the D-sub connector inside a backshell (151-0006) at the completion of the crimping

process.

5.1.6 Secure the strain relief using the screws provided in the backshell kit.

5.1.7 Install the thumbscrews and close the backshell with the screws.

5.1.8 Attach the backshell to the interface 453-0041 using a torque between 1.5 and 2.0 in-lb (.7 to .22

Nm) at the completion of the entire wiring process.

NOTE: Accidently attaching the interface 453-0032 to the backshell instead of the 453-0041 does

not harm the ELT, the toggle switch 140-3349, or any of the interfaces. The outcome is

that the ELT cannot be activated remotely through the toggle switch 140-3349.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Keine Kommentare

COBHAM C406-2 SERIES Spezifikationen Seite 15